Press Room Equipment In-Stock Units
Pallet Uncoiler
- 3,500 lbs. Capacity
- 42 In. Diameter Table 0-12 Table RPM
- ½ HP DC Drive Motor 20/1 Gear Reducer
- Basic Control 110 VAC Input
- 6” Wide Guide Drum & Slide Block Assembly
- Table Mat Floor Bolt Down Tabs
- Unit Weight-390 lbs. 4.8 Amps
Single Arbor Motorized Payout Reel
- Maximum Material Width 18 in.
- Maximum Arbor Capacity 4,000 lbs.
- I.D. Expansion Range 15 to 20 in.
- Maximum Coil OD Capacity 60 in.
- Motorization – 2Hp DC, 220V, 1Ph
- Arbor Speed Range 0 to 22 RPM
- Variable Speed DC Regenerative Drive
- Reversing Switch
- Loop Arm Speed Control
- 3 Self-Centering Coil Support Shoes
- Coil Keeper Arms (6 per arbor)
- 3 Quick Release Coil Keeper Arms
- Electrical Disconnect Switch
Electronic AC Servo Driven Roll Feed
- Maximum Material Width 12 in.
- Stock Thickness Capacity at Full Material Width (Based on Mild Steel) .144 in.
- Feed Roll Diameters 2.00 in.
- Maximum Feed Length 0 to 999.999 in.
- User Supplied Incoming Voltage 460V, 3Ph, 60Hz
- Pneumatic Pilot Release.
- Precision machined dowel pinned and bolted construction.
- Brushless AC Servo Drive closed loop feed back system with control diagnostics.
- Remote pendant control – Jog forward and reverse – with coiled cord.
- Driven upper and lower precision ground feed rolls.
Pull-Thru Straightener
- Maximum material width 6 1/2 in.
- Maximum material thickness capacity (mild or low carbon steel) .030 in.
- Number of Rolls 5 ea.
- Number of Adjustable Rolls 2 ea.
- Diameter of Rolls 1-1/2 in.
- Heavy-Duty Needle Bearings
- Independent Worm Gear Roll Adjust
- Hardened Entry Guides
- Hardened & Ground Straightening Rolls
- Machined Side Plates
- Lube Fittings at Each Roll
